[ RadSafe ] Need advice Moving large Pb shield

[Cary Renquist]

I will "third" or "fourth" the recommendation to get some professional
riggers.

Best regards,
Cary

---
Cary Renquist
cary.renquist at ezag.com

-----Original Message-----
From: radsafe-bounces at health.phys.iit.edu
[mailto:radsafe-bounces at health.phys.iit.edu] On Behalf Of Robert J.
Gunter, CHP
Sent: Tuesday, 05 March 2013 9:01 AM
To: 'The International Radiation Protection (Health Physics) Mailing
List'
Subject: [ RadSafe ] Need advice Moving large Pb shield

Greetings All,


We are trying to move a Canberra Model 747 Pb shield into a room and
onto
its stand and need some advice.  We can get it into the room with a
forklift
and even set it onto the stand, but must then move it about 8 feet.  We
are
concerned with moving it while loaded on the stand as it will be top
heavy.
We cannot get the forklift into the room.  The unit weighs 3000 lbs and
has
lifting eyes.


I am sure someone out there has done this and can give some advice.  I
would
much prefer to lift the device onto the stand once in the room, but am
not
familiar with small enough portable equipment capable getting into the
room
through a 36" door and lifting this 3000 lb device.  Another way we
could do
this is to load it onto the stand with a forklift from outside the room
and
then "slide" it over about 10 feet.  This does not seem like a very safe
way
to do this since it is so top heavy.

 

Perhaps there are lifting devices that can be rented?

Any advice would be appreciated.

 

Yours,

Rob

 

Robert J. Gunter, MSc, CHP

CHP Consultants/CHP Dosimetry

www.chpconsultants.com

www.chpdosimetry.com

Toll Free: (888) 766-4833

Fax:  (866) 491-9913 

Cel:  (865) 387-0028

rjgunter at chpconsultants.com

 

_______________________________________________
You are currently subscribed to the RadSafe mailing list

Before posting a message to RadSafe be sure to have read and understood
the RadSafe rules. These can be found at:
http://health.phys.iit.edu/radsaferules.html

For information on how to subscribe or unsubscribe and other settings
visit: http://health.phys.iit.edu