[ RadSafe ] Thermo EPD Mk2 dosimeter software?

[Perle, Sandy]

You can contact Thermo and ask them for support:

800 274 4212
Address:27 Forge Parkway
Franklin, MA 02038


-----------------------------------
Sander C. Perle
President
Mirion Technologies
Dosimetry Services Division
2652 McGaw Avenue
Irvine, CA 92614

+1 (949) 296-2306 (Office)
+1 (949) 296-1130 (Fax)

Mirion Technologies: http://www.mirion.com/



On 5/23/11 8:17 PM, "Dan Zenchelsky" <danz at danz.com> wrote:

>Correction:  It's a Thermo EPD Mk2.  (was originally manufactured by
>Siemens but now by Thermo)
>
>Question is the same - does anyone know how to get this unit unstuck
>from the "OFF" mode?  :)
>
>Thanks
>-Dan
>
>-----Original Message-----
>From: Dan Zenchelsky
>Sent: Monday, May 23, 2011 5:25 PM
>To: 'radsafe at health.phys.iit.edu'
>Subject: Siemens EPD Mk2 dosimeter software?
>
>Hi All,
>
>Does anybody happen to have the software needed to configure a Siemens
>EPD Mk2 dosimeter?   I just picked up a used unit, but it is stuck in
>the "OFF" mode and apparently it can only be unlocked with the
>provisioning software.
>
>It looks like it communicates to a PC via IR.
>
>Anybody have any ideas?
>
>Thanks
>-Dan
>
>_______________________________________________
>You are currently subscribed to the RadSafe mailing list
>
>Before posting a message to RadSafe be sure to have read and understood
>the RadSafe rules. These can be found at:
>http://health.phys.iit.edu/radsaferules.html
>
>For information on how to subscribe or unsubscribe and other settings
>visit: http://health.phys.iit.edu


PROPRIETARY INFORMATION NOTICE:   This e-mail message and all attachments transmitted with it are intended solely for use by the addressee and may contain proprietary information of Mirion Technologies and/or its affiliates.  If the reader of this message is not the intended recipient, you are hereby notified that any review, dissemination, distribution, copying or other use of this message is strictly prohibited.  If you have received this message in error, please notify the sender immediately by replying to the message, delete the original message and all attachments from your computer, and destroy any copies you may have made.  Thank you.